Yokogawa DAQWORX Bedienungsanleitung PDF herunterladen (Seite 18)

1-5

IM WX104-01E

Before Use

Index

1.3 Configuring the Network

The network must be configured so that the RECORDER and the PC can communicate

properly using DAQEXPLORER.

Set the network configuration on the RECORDER side.

For the configuration procedure, see the respective communication interface user’s

manual.

Press the MENU key to display the setting mode menu.

2. Press the FUNC key for approximately three seconds to display the basic setting

mode menu.

For the DX100/MV100/CX1000

3. Press the [#10 (Communications)] soft key ([#9] (Communications) soft key on

CX1000), then the [#1 (Ethernet, IP address)] soft key. Then, press the [#2 (Ethernet,

DNS)] soft key.

For the DX200/MV200/CX2000

3. Press the [#6 (Communications)] soft key ([#7] (Communications) soft key on

CX2000), then the [#1 (Ethernet)] soft key to display the following communication

function menu:

5. Enter a name.

4. Enter these three parameters.

With the DX1000

3. Choose Communication (Ethernet) > IP address. Enter the IP address, subnet

mask, and default gateway, then choose Communication (Ethernet) > Host

settings, and enter the host name.

With the DX2000

3. Choose Communication (Ethernet) > IP address, Host settings, then enter the IP

address, subnet mask, default gateway, and host name.

* Host name The name that is specified here is used as an identification name for the RECORDER

that can be mounted from within the network folder. If a name is not specified, the IP

address will be used as the identification name.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 335 336

Keine Kommentare

Yokogawa DAQWORX Bedienungsanleitung Seite 18