Yokogawa DAQWORX Bedienungsanleitung PDF herunterladen (Seite 50)

4-3

IM WX102-01E

Index

DARWIN Hardware Configurator

4.2 Loading Setting Data

Loading setting conditions when Hardware Configurator closed last.

Startup DAQ 32 Plus and select the desired Project using the Launcher’s Project

Settings. (See Section 2.3, “Switching and Protecting Projects”).

The setting conditions at the moment the Project was closed for the last time will

appear when Hardware Configurator is opened.

Loading settings from the hardware connected to your PC.

Startup DAQ 32 Plus and select Hardware Configurator with the Launcher toolbar.

Select Comm. > Receive from the menubar (see below).

When asked Start Receiving? click OK to start loading down settings from the

DA100/DC100/DR.

Note

• Data cannot be received when the Logger Monitor or Record function is active.

• When using ether communication, error detection may take a few minutes.

• When data were acquired with the DC100, a message may appear warning you that some

changes have taken place. In that case, please check if all data have been acquired.

Loading data earlier saved to your PC’s harddisk or to a hardware

floppydisk.

It’s possible to open the following data files.

.ast: Data le received from a DA100.

.rst: Data le received from a DR.

.cst: Data le received from a DC100.

.set: Data le containing SET (Regular) Settings created with a DC100 or DR.

.pnl: Data le containing SETUP (Basic) Settings created with a DC100 or DR.

When reading DC100 (.pnl) data, you may gat warned for data changes or

incomplete loading. In that case, please check if all data have been acquired.

Startup DAQ 32 Plus and select Hardware Configurator with the Launcher toolbar.

Select File > Open... from the menubar, or click the File Open icon on the toolbar.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 209 210

Keine Kommentare

Yokogawa DAQWORX Bedienungsanleitung Seite 50