Yokogawa Data Acquisition with PID Control CX2000 Bedienungsanleitung PDF herunterladen (Seite 41)

2-29

IM04L41B01-65EN

Index

Viewing and Creating Setup Data

Setting the Modbus Master

Set the command.

Data type

Select whether or not use command.

Address (slave device)

Communication input data (DX100P: C01 to C12,

DX200P: C01 to C30)

• Basic

Read cycle: The cycle at which data is read from other devices. Select the read cycle

from [125 ms], [250 ms], [500 ms], [1 s], [5 s], [2 s], or [10 s]

 Timeout:SpecifyatimeperiodthattheDXPwaitsforaresponsefromthespecied

slave device after transmitting a command. Select the timeout time from [125 ms], [250

ms], [500 ms], [1 s], [5 s], [2 s], [10 s], or [1 min].

Retrials: The number of times to retransmit the command when there is no response

fromthespeciedslavedevice.Selectthenumberofretrialsfrom[Off](0),[1],[2],[3],

[4], [5], [10] or [20].

• Type

• INT16:16-bitsignedinteger 

• UINT16:16-bitunsignedinteger

• INT32_B:“32-bitsignedinteger”isassignedtotheModbusregisterintheorder

upper 16 bits followed by the lower 16 bits.

• INT32_L:“32-bitsignedinteger”isassignedtotheModbusregisterintheorder

lower 16 bits followed by the upper 16 bits.

• UINT32_B:“32-bitunsignedinteger”isassignedtotheModbusregisterintheorder

upper 16 bits followed by the lower 16 bits.

• UINT32_L:“32-bitunsignedinteger”isassignedtotheModbusregisterintheorder

lower 16 bits followed by the upper 16 bits.

• FLOAT_B:“32-bitoating-pointdata”isassignedtotheModbusregisterinthe

order upper 16 bits followed by the lower 16 bits.

• FLOAT_L:“32-bitoating-pointdata”isassignedtotheModbusregisterinthe

order lower 16 bits followed by the upper 16 bits.

2.6 Configuring the System Mode

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 54 55

Keine Kommentare

Yokogawa Data Acquisition with PID Control CX2000 Bedienungsanleitung Seite 41