Yokogawa Standalone MW100 Bedienungsanleitung PDF herunterladen (Seite 18)

4.5 Communication Considerations

About Communication Interval

Data Update

The DX Advanced and MW100 data is updated in a scan interval. Even if a PLC accesses the data at shorter

intervals than the DX or MW100 scan intervals, the data is updated only at scan intervals.

Communication Interval

A PLC should access the DX or MW100 at intervals of 125 ms or longer. * This is required to maintain

compatibility with other protocols supported by the DX than EtherNet IP.

Access to Non-existent Data

If non-existent data is accessed, either of the following operations occurs. • 0 is read if non-existent data is read.

Nothing is done if non-existent data is written.

When the DX Data Type Differs from the Data Type Specified in a Command

Each data set on the DX/MW100 has a fixed data type. Data on the DX/MW100, which includes special data,

accessed using the same data type is transmitted unchanged. Data on the DX/MW100 accessed using a different

data has its data type converted. The following explains the conversion rules:

4.3 DX Instance ID Map for Implicit Messaging

4.4 MW100 Instance ID Map for Implicit Messaging

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Keine Kommentare

Yokogawa Standalone MW100 Bedienungsanleitung Seite 18