Yokogawa DA100 Bedienungsanleitung PDF herunterladen (Seite 62)

IM DA100-11E

6-10

p4 Storage selection (ABORT, STORE)

Example Store the calibrated values for the module in slot

1 of subunit 0.

XZ0, 1, END, STORE

Comments • Connection

DC Voltage Measurement : Input a DC voltage

according to the measurement range to CH3.

CH2 is short-circuit.

Temperature Measurement using RTD : Input

100Ω to CH5. CH4 is short-circuit.

• Caribrate the high sensitive RTD after

calibrating of 60mV and 200mV ranges.

• Be sure to execute STORE using A/D

calibration end processing every time an A/D

calibration/adjustment for one module is

completed. If A/D calibration end processing

(STORE) is not executed, the calibrated data

are ineffective.

• Since it takes an indefinite time to execute an

XZ command, return an ACK after the

processing is over.

On the controller side, execute the following

processing after receiving the ACK after

transmitting an XE command. The ACK status

format is as follows:

E0Cr+Lf: The received command has been

normally processed.

E1Cr+Lf: There is an error in the received

command.

6.2 Control Execution

Command

AR Executes an alarm reset.

Mode Operation mode

Setting ARp1<terminator>

p1 0, Execute the alarm reset.

Example Execute the alarm reset.

AR0

IR Executes an alarm reset.

Mode Operation mode

Setting IRp1<terminator>

p1 0, Execute the timer reset.

Example Execute the timer reset.

IR0

EX Computation start/stop, restart of

computed data after they are cleared,

and release of statuses after

completing measurement

Mode Operation mode

Setting EXp1<terminator>

p1 Computation start/stop, restart of

computed data after they are cleared, and

execution of releasing statuses after

completing measurement.

0: Computation start

1: Computation stop

2: Restart of computed data after they are

cleared

3: Computed data clear

4: Release of statuses after completing

measurement

Example Start the computation.

EX0

Comments • This command only works with the optional

computation function or if a pluse module is

installed.

• If MATH is set for level action in the event/

action, a computation start/stop/start after

clearing the computed data cannot be done

using the EX command

BL Executes the initial balancing of the

strain input channel

Mode Operation mode

Setting BLp1, p2, p3<terminator>

p1 The first channel for executing the initial

balancing

p2 The last channel for executing the initial

balancing

p3 Select either initial balancing or

initialization

EXEC: Execute initial balancing

INIT: Execute initialization

Example Execute initial balancing on subunit 0 and

channels 01 to 08.

BL001, 008, EXEC

Comments • Channels other than strain input channels or

channels that are not connected within the

specified range are ignored.

• Initial balancing and initialization can not be

executed during a report.

6.2 Control Execution Command

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 104 105

Kommentare zu diesen Handbüchern

Keine Kommentare

Yokogawa DA100 Bedienungsanleitung Seite 62

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Yokogawa DA100