Yokogawa DA100 Bedienungsanleitung PDF herunterladen (Seite 20)

IM DA100-11E

3-1

Overview and Specifications of RS-422-A/RS-485 Interface

3.1 Description of Functions (RS-422-A/RS-485)

Listener and Talker Functions

Listener Function

This allows almost all settings except power on/off and operation control.

• Settings except communication settings.

• Operation control except power on/off.

• Call-up of setting data

• Specifying of output data (specifying of channel numbers or output data types)

Talker Function

The following data can be output:

• Measured data

• Report data

• Data for relay condition

• System configuration

• Data for operation mode setting

• Data for setup mode setting

For measured data, either binary output or ASCII output can be selected. (for RS-422-A with using

the multi point.) Report data and data for relay condition are output in binary format. Other data are

output in the form of ASCII data.

Data Output

When trigger(GET) becomes activated DA100 will store the new data in a buffer. When an output

request such as the FM command is received, these new data will be output.

Commands Applicable to RS-422-A/RS-485 Only

The following commands are only applicable to RS-422-A/RS-485.

ESC O Open Command (address a communication destination)

Setting ESC O xx<terminator>

xx : address, 01 to 31

Description Specifies the communicating device by its address. When this command is ex-

ecuted, all commands to the DA100 (including ESC T) become effective.

• Only one device can be opened.

• Executing ESC O automatically closes all opened devices.

• When the DA100 receives this command correctly, it sends “ESC O xx” in

response to the computer.

• CR+LF can only used for the terminator.

ESC C Close Command (close the addressed state of a device)

Setting ESC C xx<terminator>

xx : address, 01 to 31

Description Disconnects the device currently connected. When this command is executed, it

allows opening communication with other devices with the ESC O command.

• When the DA100 receives this command correctly, it sends “ESC C xx” in

response to the computer.

• CR+LF can only used for the terminator.

The following commands are same as the RS-232-C interface. Refer to User’s Manual shown

below.

ESC T (Trigger Execution), ESC S (Status Output Command)

Note

• ESC corresponds to hexadecimal code (1B)H. On the N88-BASIC, “ESC x” is denoted as “CHR$(&H1B)+”x”.”

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 104 105

Kommentare zu diesen Handbüchern

Keine Kommentare

Yokogawa DA100 Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Yokogawa DA100