Yokogawa Standalone MW100 Bedienungsanleitung PDF herunterladen (Seite 28)

IM CA150E

Address 0 communications need to be retransmitted over the serial port connected to the SLC504

. Set Protocol to DF1 Full-

Duplex and Serial Port to 2.

Click Next to accept defaults until returned to this screen and then check Continue creating more message destinations and

Next.

Now it is time to route communications to the MW100. In this case, all read and write commands issued from the SLC504

this example are sent to Node 5 (it could be set to read or write to any other address). If the SLC504

is going to write to devices

with different addresses, then conﬁ ne the address to just the address of the speciﬁ c MW100. In this example the IAP will route

any message with an address of 5 to 255 of the MW100. Click Next to continue.

1 2 ... 23 24 25 26 27 28 29 30 31

Keine Kommentare

Yokogawa Standalone MW100 Bedienungsanleitung Seite 28